HAAS® Alarm 118 — SPINDLE LOW GEAR FAULT
Part of: our HAAS® alarm reference · covering 60 of the most common alarms.
What it means
Gearbox failed to shift into low gear. Same family as 117, opposite direction.
Common causes
- Same as 117 — air pressure, solenoid, fork wear, sensor
What to check first
- Check air pressure first
- If air is fine, this is a service call to inspect the gearbox
Prevention
Most spindle alarms have one of two root causes: heat or load. A clean cabinet with working fans, sensible cutting parameters, and a regular spindle warm-up cycle (especially on cold mornings) prevents the majority of spindle issues. If your spindle load gradually creeps up across a long production run, replace the cutter sooner rather than later.
If you’re still stuck
If you’ve worked through the checks above and the alarm hasn’t cleared — or if it cleared and came back — that’s the point to call. Persistent alarms after a reset usually mean a real component fault, and pushing through them risks turning a simple repair into a bigger one. Keith covers HAAS® breakdowns across the UK with same-day phone diagnosis.
A note on this guide. Alarm wording and numbering can vary by HAAS® machine model and software revision. The descriptions here are written in plain English to help you understand what the machine is reporting and what to check first — they’re not a substitute for the official HAAS® operator manual or for a qualified service engineer’s diagnosis. Always confirm the exact alarm message on your screen and consult your machine’s documentation before attempting any repair.